Sunsynk LifeLynk XL 5.5kW Hybrid Inverter with 5.2kWh Battery
The Sunsynk LifeLynk XL (SM5.5kWLL) is an all-in-one 5.5 kW single phase hybrid inverter with a 5.22 kWh LiFePO4 battery built in. Solar, battery, grid and generator are managed by one wall-hung unit, not a separate inverter and battery cabled together on site.
It accepts up to 6,800 W of PV on two MC4 inputs and delivers 5.5 kW at 230 V AC, at up to 97.6% efficiency. It can run on-grid, off-grid or as a UPS for the circuits it backs up.
Solar input
The PV side takes up to 500 V, with an MPPT range of 120-450 V and a 150 V start-up voltage. Maximum PV current is 16 A, the total across both MC4 sets combined, and MPPT efficiency is 99.9%. Sunsynk's commissioning check is that panel Voc must not exceed 450 V, so design strings to stay under that on the coldest morning.
AC and battery
Nominal input and output is 5,500 W / 5,500 VA at 230 V, 50 Hz, with 24 A maximum current and a power factor range of 0.8 leading to 0.8 lagging. In standalone mode it delivers the same 5,500 W, with under 3% THD. The internal LiFePO4 battery works between 43.2 V and 57.6 V and charges at up to 90 A and discharges at up to 120 A, both configurable. Battery-to-load efficiency is 94.0%.
Control and protection
Supply priority (battery or grid) and the operating mode are programmable, and monitoring is by Wi-Fi or GSM. Export control can be set to zero export. An earth-neutral bond relay can switch in on the load port when the grid fails, so earth-leakage devices keep working on the backed-up circuits. Protection covers overload, over-temperature and short circuit.
Installing it
The unit is IP20, so it must go indoors. It measures 901 x 624 x 182 mm and weighs 82 kg net (92 kg packed), and goes on our pallet service. Sunsynk ask for about 500 mm clear to each side, above and below, and 1,000 mm in front. The inverter runs from -20 °C to +50 °C (derating above 35 °C). The battery charges from 0 °C to +50 °C and discharges from -20 °C to +50 °C. The user manual is in the Documents tab.
Order alongside
-
Sunsynk SDM120CT-M Digital Meter (Single-Phase)
Sunsynk's single-phase CT meter. Check the LifeLynk XL manual to see whether your export setup needs one.
Alternative sizes
Other Sunsynk ways to get solar, storage and backup.
-
Sunsynk Lifelynk X 3.6kW Hybrid Inverter with 3.84kWh Battery
The smaller LifeLynk, 3.6 kW with a 3.84 kWh battery, for smaller homes and arrays.
-
SunSynk Acure 5.0kW Single Phase Hybrid Inverter (White)
A separate 5 kW hybrid inverter, if you want to choose and size the battery yourself.
-
Sunsynk 5.32kWh IP65 W5.3 White Battery (Including Cable Sets)
A standalone IP65 Sunsynk battery for a split inverter-and-battery system.
The inverter must be installed by a qualified / licensed electrical engineer in accordance to the countries wiring regulations.
Questions on the LifeLynk XL
Yes. One 5,223 Wh LiFePO4 battery is installed inside the unit.
No. It is rated IP20, so it is for indoor installation.
Up to 6,800 W across the two MC4 inputs, at up to 500 V and within a 120-450 V MPPT range.
Single phase, 230 V.
Sunsynk's user manual does not state the warranty term, and it is not yet published on this page. Ask us before you order.
Electrical
| Rated Power (Pmax) | 5,500 W |
|---|
Most orders are delivered the next working day, subject to the delivery method, product availability, order processing time and destination. Next-working-day delivery is typical for standard deliveries and is not guaranteed for every order.
Pallet deliveries may take an additional day or so, depending on the products ordered, the delivery location and the carrier’s schedule. Special delivery arrangements may also require additional time.
Please refer to your tracking information for the latest delivery updates.







